VALVE REGRIND GASKETS & HEAD BOLTS COMBO FOR HOLDEN COMMODORE VT ECOTEC L36 3.8L V6 TO ENG. VH756061

This Valve regrind gasket set and head bolts combo pack suits Holden Commodores and similar platforms fitted with Ecotec L36 3.8L V6 engine (engine number VH699661 to VH756061).
Mace VRS gasket set has been designed to meet and exceed OEM specifications. Each item of this kit has been checked and evaluated, so you can be assured of quality fitment every time.

The Head bolts included in this pack are best suited for standard and mildly modified applications. These are a torque-to-yield (TTY) type bolt which means they can be tightened past their elastic limit, guaranteeing high and uniform clamping forces. Other benefits include pre-applied sealant to the threads eliminating the use of thread locker and no-retorquing is necessary after correct installation procedures have been followed.

This valve regrind gasket set and head bolts combo pack suits Holden Commodores and similar platforms fitted with the Ecotec L36 V6 engine.

Contents:

• 01 X Platinum Cylinder head gasket set
• 01 X Platinum Exhaust manifold gasket set
• 01 X Platinum Intake manifold gasket set
• 01 X Platinum Seal strip set
• 01 X Platinum Rocker cover gasket set
• 01 X Platinum Plenum cover gasket
• 01 X Platinum Thermostat gasket
• 12 X Platinum Rocker cover bolt seal
• 12 X Platinum Valve stem seal
• 16 X Mahle Head bolt (enough for one motor)
• Other small gaskets and seals

Vehicle Fitment Guide

Notes:

• The valve regrind gasket set and head bolt combo pack to suit Ecotec L36 V6 engine (up to engine number VH699660), can be purchased through another listing.
• The valve regrind gasket set and head bolt combo pack to suit Ecotec L36 V6 engine (engine number VH756062  onwards), can be purchased through another listing.
• This gasket set does not include throttle body to plenum gasket, front inlet heater pipe o-ring and several other gaskets/seals/o-rings that are of little or no importance.
• When torquing up bolts, an accurate torque wrench or angle gauge will be required to achieve correct clamping forces.
• Please follow the torque specifications as recommended by the service manual.
• TTY bolts are only to be utilized once due to permanent elongation and safety concerns.
• These components included in this combo pack can be purchased separately through other listings.