MACE MANIFOLD INSULATOR TO SUIT FORD BARRA 220 230 5.4L V8

Product no.: MI802
NZ$110.00
Delivery Estimator Calculates delivery cost for this product


Exclusive to MACE Engineering, our design-registered 6.35mm (1/4") manifold insulator to suit Ford Barra 220 and 230 V8 engines.


Key benefits:

  • Produces a cooler intake charge resulting in more power
  • A cooler intake charge also reduces the tendency for detonation, means more ignition timing/boost for more power!
  • Improves low end torque by increasing runner length
  • Better fuel economy
  • Robust insulator material allows it to be re-useable
  • No undesirable side effects

 

What are manifold insulators and what do they do?

Manifold insulators are a thermal insulating spacer that mounts between your upper and lower intake manifold. Made from a heat blocking composite, our manifold insulators will increase power from your engine by keeping the intake cooler, and increase low end torque by increasing runner length.

 

             HotCold-Intake

 

But how do manifold insulators keep the intake manifold cooler?

Given our manifold insulators are made from a composite material with a thermal conductivity of 0.29 W/m*K as opposed to aluminium, which has a thermal conductivity of 150 W/m*K; The difference works out to be that aluminium conducts heat 500 times higher than our composite material!

Also, with gaskets often made out of steel (20 W/m*K thermal conductivity), placed between the upper and lower manifolds, replacing a .5mm gasket with a 6.35mm insulator will conduct an amazing 688 times less heat (yes, that's over 70,000% reduction!). What this basically means is that it becomes very difficult for the engine to heat up the manifold, which ultimately means more power for extended periods (i.e. considerably fewer heat soak issues)!

Our composite material also exhibits high stiffness and compressive strength, can withstand temperatures of up to nearly 150 degrees celcius, and has a thermal expansion coefficient very similar to aluminium to increase sealing capabilities. In addition, the spacer can also withstand boosted conditions with ease.

 

Contents:

  • Barra 5.4L V8 manifold insulator

  • Bolt pack

  • Silicone gasket maker

 

What about Installation?

Installation is straight forward, requiring only the removal of your inlet manifold to install the manifold insulators. We currently don't have any fitting instructions for these insulators given the simplicity of the install.

 

Vehicle Fitment Guide

table_for_MI802

 

Browse these categories as well: Manifold Insulators, V8