MACE 69MM BORED OUT THROTTLE BODY TO SUIT HOLDEN ECOTEC L36 L67 SUPERCHARGED 3.8L V6 (1995-2002)

Product no.: TB601
NZ$366.00
Delivery Estimator Calculates delivery cost for this product


Installing a bored out throttle body is a very cost-effective way to bump up the performance of your Ecotec or L67 supercharged 3.8L V6 engine by increasing airflow by 14%.

Designed and manufactured by a team of qualified mechanical and automotive engineers, so you can be assured of the outstanding quality and workmanship of these re-manufactured throttle bodies. The photo does NOT do these throttle bodies justice!

Through different testing procedures, gains of around 10hp at the rear wheels have been recorded if used in conjunction with extractors/exhaust and cold air intake. A greater power gain can be achieved with additional mods such as a larger cam and supercharger etc.

On top of this power increase, it will also make your engine sound meaner (i.e. more air rushing into the engine) and offer a much better throttle response.

Please note that we don't manufacture these throttle bodies in 70mm as we feel that they are unsafe in long term since the wall thickness is too thin and may fail over time.

These throttle bodies have been fitted to a number of cars including David Wilzig's ITT.38L, which was the FASTEST V6 IN AUSTRALIA, pulling 9.981 seconds @ 137.88mph down the quarter and making 750hp! So these products have been well proven to work even on the most extreme cars.

 

10jpeg

 

2461_3mgx420

 

As you can see on the before and after dyno graphs, a VY Commodore with manual transmission, extractors/exhaust and chip have made 161.2hp at the rear wheels. After changing leads, spark plugs and installing our larger throttle body power jumped to 176.9hp at the rear wheels.

 

Power Run - Standard Throttle Body

beforethrottlepowerlogosmallBORDER

 

Power Run - Larger Throttle Body

afterthrottlepowerlogosmallBORDER

 

Please note that our throttle bodies use a brand new 69mm brass butterfly to match the bored out throat. Other products on the market are merely a cleaned up version of the factory item and still use the original butterfly which leaves the main restriction to airflow in place. This is done to mislead people into thinking that they are selling a larger throttle body when they actually are not! To be sure, it is best to ask for photographic proof that the butterfly diameter is what they claim it to be.

 

Measured Throttle Body

ECOMEASUREDSMALL

 

Vehicle Fitment Guide

TB601_Throttle_Body_Holden_3.8L_V6__VFG01

 

Notes:

  • These throttle bodies are not polished.
  • Vehicles equipped with automatic transmissions will require a tune as the shift points are altered by fitting this throttle body. We can provide a re-calibrated PCM or memcal to suit.
  • For customers with either Caprice/Statesman WH or Monaro V2.II models later than 09/02, we recommend to check the throttle body to determine if they have VX or VY type. If you are unsure, please send us a picture of the IAC mounting boss on top of the throttle body to determine it for you.
  • Mace bored out throttle body to suit Holden VY 3.8L V6 can be purchased through another listing.
Browse these categories as well: Throttle Bodies, V6, 3.8L Ecotec V6, L67 Supercharged 3.8L V6